Supporting Cameras with Analytics
When using cameras with supported edge-based analytics, a wired Digital Input trigger is not needed. The Bridge still requires power, internet service, and in most cases, an arming input from the alarm panel. Using the alarm panel arming state allows the Bridge to ignore camera analytics when the alarm system is disarmed. All configuration for camera analytics is done on the camera, or the manufactures recommended software. Use the CHeKT Dealer Portal to program the Bridge to create alarm events and video events based on analytics from the camera.
Alarm Communicator Configuration: A central station's
CHeKT Signal Delivery setup is required if an integrator is installing the CHeKT hardware as a stand-alone alarm communicator or using video analytics to transmit alarm traffic through the CHEKT Bridge. All Systems need to be properly tested to ensure your Central Station is receiving alarm information and video.
Related Articles
CHeKT Pro AI Camera Series - Analytics Manual
The latest licenced plug-in is a set of analytical tools loaded on our cameras that provides the means to perform advanced analytics, reduce false alerts and customize when events occur. This article will describe how to enable and configure the ...Analytic Triggers: Using Camera Analytics
Analytic Events Supported analytic event triggers from a camera mounted to the bridge can generate alarm signals and video events. These events are based on a supported API connection with the camera. The network event message has topic information ...How Does CHEKT Create Alarm Signals and Video Events?
The CHeKT Video Alarm Bridge can create alarm signals and video events using a few methods. When the Bridge is used as a component or module of an alarm panel, triggered events can be programmed to only create and upload a video event, leaving the ...OPTEX InSight Cameras
OPTEX InSight Cameras The Optex InSight series are the new members of the OPTEX sensor family of outdoor detection. By combining the dual-tech sensors of an OPTEX sensor and a full HD 1080 camera, you now have a powerful Visual Verification PIR ...CHeKT AI Server Installation and Operation
1. Once power and connection are confirmed the bridge's IP and MAC can be discovered via the CHeKT bridge's Network Scan tool. The device is identified by the MAC address sticker located on the bottom of the unit. The MAC associates with LAN 2 so for ...