Wiring the Bridge
Sync Bridge and Alarm Panel Ground
Important Information: Wiring an alarm panel and zones to the Bridge: Click Here When the Bridge is powered by the alarm panel, the Bridge is sharing a common ground with the alarm panel and this is not required. If you are powering your Bridge from ...
Alarm Panel Pairing: Programming with The Bridge
Alarm Panel Pairing Mode: When a Bridge is programming in Alarm Panel Pairing mode, the Bridge is a video alarm module to the on-site alarm system. The Bridge will capture video events for all alarm zone triggers. To change your Site Programming mode ...
Qolsys and CHeKT Bridge Integration
Our CHeKT Bridge is designed to respond to the state change in continuity for ease of operation with most security intrusion devices. For wireless systems, it's typical to use an available programmable output and relay combination to apply this short ...
CHeKT Bridge Arm/Disarm Wiring Guide
Why is using the Bridge Arming Input Important? Like an alarm panel, the armed state of the Bridge will control when the Bridge input zones and events from camera analytics are active and send signals to a central station. If you set the Bridge to ...
Physical Triggers: Wiring Alarm Inputs on the Bridge
Depending on the device you are using to trigger the alarm zone on the bridge, there are a few ways you can wire into the bridge. Below are 3 examples of wiring the Bridge Alarm zones. 1. Zone Passthrough In this illustration, the Bridge is powered ...
Bridge Installation - Wiring & Setup Steps
1. Connect power Connect 12VDC power using the 4-pin terminal block included in the package. You can power the bridge using the 12 volt power output from the alarm panel. Power status LED will turn solid green when it is poweredon. The bridge can ...